As prescribed in 11.204-99 insert the following clause:
PHYSICAL ITEM IDENTIFICATION/BARE ITEM MARKING (APR 2008 LAND, MARITIME) - DLAD
Unless authorized by exclusions listed below, all items shall be marked as specified in MIL-STD-130N dated 17 December 2007. The following DSCC supplemental marking requirements shall take precedence in case of conflict with MIL-STD-130N.
DSCC Exclusion:
(a) Unless the design control document specifically cites other marking requirements, the item will be considered too small to mark under the conditions listed below (however, 52.211-9035, Marking Requirements, applies):
(1) For FSCs 5905, 5910, 5935, 5961, 5962, and 5999, items smaller than .100 inch in diameter and .250 inch in length or .100 inch square X .250 inch in length, exclusive of wire leads, will not be marked.
(2) Other FSCs managed by DSCC will not be marked if the item is smaller than .250 inch in diameter X .500 inch long or .250 inch square X .500 inch long, exclusive of wire leads.
(3) Restrictions (1) and (2) above will not preclude marking of items of smaller dimensions if it is the manufacturers or vendor's standard practice to do so.
(b) No other physical item marking exclusions are authorized unless specified by MIL-STD-130N.
(End of Clause)
